自上料攪拌車的弱點要避免掉
自上料攪拌車是工程建造中必不可少的設備，但是由于是自動設置，使用時間長后部分功能會影響整體使用，下面跟著小編了解下自上料攪拌車的弱點有哪些，這樣我們才能在使用中盡量避免掉。
Self loading mixer is an essential equipment in engineering construction, but due to its automatic setting, some functions will affect the overall use after a long time of use. Follow me to learn about the weaknesses of self loading mixer, so that we can try to avoid them in use.
齒輪箱的正常壓力范圍為1.08~1.47MPa，壓力低于1.08MPa。認為變速油壓太低，這將導致自上料攪拌車的驅動力不足，整機弱，齒輪不起動。
The normal pressure range of the gearbox is 1.08~1.47mpa, and the pressure is lower than 1.08mpa. It is considered that the variable speed oil pressure is too low, which will lead to insufficient driving force of the self loading mixer, weak whole machine and non starting gear.
減壓閥的功能是通過壓力調節彈簧將較高的輸入壓力調節到規定的輸出壓力，并確保輸出壓力的平衡。一旦減壓閥的壓力調節彈簧損壞，變速箱將不能保證正常的輸出壓力。
The function of the pressure reducing valve is to adjust the higher input pressure to the specified output pressure through the pressure regulating spring and ensure the balance of the output pressure. Once the pressure regulating spring of the pressure reducing valve is damaged, the transmission will not guarantee the normal output pressure.
壓力調節器沒有適當調整。壓力調節閥通過壓力調節閥芯控制變速器的輸出壓力。如果輸出壓力太小，變速箱油壓將太低。
The pressure regulator is not properly adjusted. The pressure regulating valve controls the output pressure of the transmission through the pressure regulating valve core. If the output pressure is too small, the transmission oil pressure will be too low.
管道油封嚴重漏油。檢查變速箱油盤到變速箱泵吸入管路是否泄漏。如果發現漏油，請修理或更換新線路。
The oil seal of the pipeline leaks seriously. Check the transmission oil pan to the transmission pump suction line for leakage. If oil leakage is found, repair or replace the line.
混凝土自上料攪拌車廠家講解該設備的驅動器問題：
The manufacturer of concrete self loading mixer explained the driver problem of the equipment:
1.通用車削部件是故障部件。應及時填充潤滑脂，并經常檢查磨損情況，及時修理和更換。車隊應該有一個備用的萬向軸組件，以確保在發生故障時能夠在幾分鐘內恢復。
1. General turning parts are faulty parts. Fill the lubricating grease in time, check the wear condition frequently, and repair and replace it in time. The fleet should have a spare cardan shaft assembly to ensure recovery in a few minutes in the event of a failure.
2.確保液壓油清潔。自上料攪拌車的工作環境不好，必須防止臟水泥砂進入液壓系統。應根據手冊的要求定期更換液壓油。一旦檢查發現水或沙子混入液壓油中，就必須立即停止液壓系統并更換液壓油。
2. Ensure that the hydraulic oil is clean. Since the working environment of the self loading mixer is not good, it is necessary to prevent dirty cement sand from entering the hydraulic system. The hydraulic oil should be changed regularly according to the requirements of the manual. Once water or sand is found to be mixed into the hydraulic oil, the hydraulic system must be stopped immediately and the hydraulic oil must be replaced.
3.確保液壓油冷卻裝置有效。定期清洗液壓油散熱器，避免散熱器被水泥堵住，檢查散熱器電風扇是否正常運行，防止液壓油溫度超標。只要液壓部件確保液壓油清潔，通常幾乎沒有故障，但制造商具有不同的使用壽命。
3. Ensure that the hydraulic oil cooling device is effective. Clean the hydraulic oil radiator regularly to prevent the radiator from being blocked by cement, and check whether the electric fan of the radiator operates normally to prevent the hydraulic oil temperature from exceeding the standard. As long as the hydraulic components ensure that the hydraulic oil is clean, there is usually almost no failure, but the manufacturer has different service life.
一般來說，如果驅動裝置由于故障停止工作，混凝土儲罐將不能正常旋轉，驅動裝置是否可靠是在使用中必須高度重視的問題。更多相關問題就來關注我們http://www.pheenet.cn了解吧！
Generally speaking, if the driving device stops working due to failure, the concrete storage tank will not rotate normally. Whether the driving device is reliable must be paid great attention to in use. Pay attention to us for more related issues http://www.pheenet.cn Understand!
下一篇：攪拌車掌握幾點會更好的使用上一篇：攪拌車各項部件的檢查事項
