炎熱夏天使用攪拌車有一些“預防”措施
混凝土自上料攪拌車是一年四季都可以使用的機器。每個季節都有不同的使用注意事項。那么在炎熱的夏天使用它應該注意什么？
Concrete self loading mixer is a machine that can be used all year round. Each season has different precautions. So what should we pay attention to when using it in hot summer?
夏季氣溫越高，燃油蒸發越快，容易造成阻氣。因此，夏季需要及時清洗燃油濾清器。行車時，我們可以用濕布蓋住燃油泵，定期噴灑，保持濕潤，可以減少空氣阻力的發生。一旦燃油系統被空氣堵塞，我們需要立即找一個的地方停車降溫，并拉動手動油泵給油路加滿燃油。
The higher the temperature in summer, the faster the fuel evaporation, which is easy to cause gas blockage. Therefore, the fuel filter needs to be cleaned in time in summer. When driving, we can cover the fuel pump with a wet cloth and spray it regularly to keep it wet, which can reduce the occurrence of air resistance. Once the fuel system is blocked by air, we need to find a safe place to stop and cool down immediately, and pull the manual oil pump to fill the oil circuit with fuel.
夏季氣溫高，發動機容易過熱。因此，在夏季，我們需要加強對發動機冷卻系統的檢查和維護，包括水箱、節溫器、水泵、風扇等，并及時補充冷卻水。當水溫超過100℃時，我們需要將車停在陰涼的地方降溫，我們可以掀開引擎蓋散熱。
In summer, the temperature is high and the engine is easy to overheat. Therefore, in summer, we need to strengthen the inspection and maintenance of engine cooling system, including water tank, thermostat, water pump, fan, etc., and supplement cooling water in time. When the water temperature exceeds 100 ℃, we need to park the car in a cool and safe place to cool down. We can lift the hood to dissipate heat.
夏季氣溫高，電池電解液中的水分蒸發快，液位迅速下降，缺水會損壞電池。我們需要及時檢查電池內的液位，及時加入蒸餾水，保證液位正常，保證電池處于良好的工作狀態。
In summer, the temperature is high, the water in the battery electrolyte evaporates quickly, and the liquid level drops rapidly. Lack of water will damage the battery. We need to check the liquid level in the battery in time and add distilled water in time to ensure that the liquid level is normal and the battery is in good working condition.
啟動前，攪拌桿應處于中位，液壓油箱油位應在規定范圍內。啟動后，先將操縱桿置于“卸料”位置，以排除攪拌筒內積水。裝料時，操縱桿置于“裝料”位置，調節攪拌筒轉速。攪拌筒內的混凝土量必須符合運輸車輛的規定。運輸前，卸料槽必須鎖定在“驅動”位置。運輸時攪拌筒應低速轉動。
Before starting, the mixing rod shall be in the middle position and the oil level of the hydraulic oil tank shall be within the specified range. After startup, first place the control lever in the "unloading" position to drain the accumulated water in the mixing drum. When loading, place the control lever in the "loading" position and adjust the rotating speed of the mixing drum. The amount of concrete in the mixing drum must comply with the regulations of transport vehicles. The discharge chute must be locked in the "drive" position before transportation. The mixing drum shall rotate at low speed during transportation.
作業結束后必須關閉內燃機，清洗料槽、攪拌筒進口和托輪，并混凝土結塊。進入攪拌筒進行清洗時，取下內燃機電鑰匙，鎖好門窗，并在筒外設置監護人。操作完畢，將各把手置于中位，鎖好門窗。
After the operation, the internal combustion engine must be shut down, the material tank, the inlet of the mixing drum and the supporting wheel must be cleaned, and the concrete caking must be removed. When entering the mixing drum for cleaning, remove the key of internal combustion engine, lock the doors and windows, and set a supervisor outside the drum. After the operation, put each handle in the middle and lock the doors and windows.
混凝土自上料攪拌車廠家提醒您，寒冷季節應采取防凍措施，化油器不宜用明火預熱。在車下進行保養檢修時，應關閉內燃機，拉緊手剎，并牢牢系住車輪。
The manufacturer of concrete self loading mixer reminds you that anti freezing measures should be taken in cold seasons, and the carburetor should not be preheated with open fire. When carrying out maintenance under the vehicle, turn off the internal combustion engine, tighten the hand brake and firmly tie the wheels.
炎熱夏天使用攪拌車有一些“預防”措施的相關內容便是如此了，更多內容就來網站www.pheenet.cn咨詢吧！
There are some "preventive" measures related to the use of mixer in hot summer. For more information, please consult the website!
